Heat Reflecting Coating
2-3 square meters/KG/coat (two layer)
Low heat capacity
Strong flexibility Heat Reflecting Anti-sunshine Coating
Package: 20KG/drumColour: White
Theoretical coverage :
3 to 5 square meters/KG/coat(two layer)
3 to 5 square meters/KG/coat(Two layer)
The practical consumption may vary with substrate condition,
construction methods, environment and other factors.
Storage Condition: Store in cool, dry and ventilated place,away from fire.
SAILI Heat insulation flexibility exterior coating adopts advanced
aerospace adiabatic technology. It can form excellent adiabatic
coating with “three high and one low” properties: high
reflectivity, high emissivity, high heat resistivity and low heat
capacity, which can low the surface and inner temperatures of the
substrate, and cut down by thirty percent of the electrical energy
consumed by airconditioner. The energy-saving effect is obviously.
Scope of application:
Can be used for the surface of concrete floor and walls, container
need to isolate the solar thermal radiation.
Theoretical consumption of paint: 3~4 Square meter/L, (two layer,
0.2~0.3mm dry film thickness the practical dosage may vary with
substrate condition, construction methods and other factors.
Dilution:No more than ten percent of water needs to be added to dilute for
the sake of application convenience.
Repainting time: Dry for more than two hours before subsequent
application (25°C, seventy percent of relative humidity).
Color:White is recommended, and can be adjusted with water-based
colourant if necessary.
Construction methods: Can be used by brushing, rolling or spraying.
Construction procedure of wall: Construct exterior wall putty for
2~3 times → brush exterior wall special primer 1 time → brush
thermal insulation coatings 2 times → acceptance checks.
Substrate requirements: Substrate surface should be clean, dry,
smooth, firm, no grease and no rust, etc., the water content of
cement-based surface should not exceed 10%, and PH value should
Application conditions: Application temperature 5~40 °C, the
maximum relative humidity should be less than 85%. Avoid
application on windy, rainy, foggy and high air temperature
weather. After coating, keep away from rain more than 3 hours.